Podolsk,
14 Lobacheva st.
To contact page
RU EN
Tue-Fri 11:00-20:00
Sat-Sun 11:00-17:00
Mon - Closed

StuntQuad Based on a Suzuki LTR450

ATVs are gaining popularity, including among stunt riders! Four wheels allow more acrobatic tricks, more confident wheelies and tandem tricks. The best-known pro rider in this class in Russia is Valery Kulesha. He rides a Suzuki LTR 450 for the PRT team. Valera shared his experience of preparing a quad for stunt riding with us!

Engine

The engine is stock; there are no problems with oil starvation or fueling, since it has fuel injection.

Suspension

The suspension is stock. Valera lowered the springs slightly and set them as stiff as possible so the quad doesn't pitch under hard braking and acceleration.

Brakes

An oversized rear brake disc is fitted. For the foot brake, the stock caliper has been replaced with a four-piston Brembo.

The handbrake also uses a four-piston Brembo caliper. The master cylinder is a 13 mm Magura. The handbrake is linked to a foot brake on the front bumper, which allows unique tricks when the rider sits high on the handlebar. The linking has drawbacks: you have to pump up the handbrake (make a few idle presses) after using the brake on the bumper. An RSC master cylinder is fitted for an easy clutch pull.

The front brake master cylinder has been replaced with one from a Yamaha R6, since the stock one has an integrated brake reservoir, which really gets in the way of tricks in the high chair position.

Protection

Foot traps are fitted: the most important setup on quads! If you miss the footpeg, your foot will slip through, which is very dangerous on the move. The trap keeps your foot from slipping through.

The 12 o'clock bar is fitted in place of the stock one in the standard mounting points.

Pegs

There are rear pegs by the passenger seat. The pegs are attached to brackets welded to the frame.

At the front there is a bumper with pegs that let you hook your feet securely when doing tricks.

Additional modifications

Idle adjustment is routed via an electric motor to an adjustment ring under the handlebar platform (the red wire on the left).

A switch to force the fan on is wired to a toggle to the right of the handlebar.

There is a special platform on the handlebar for sitting comfortably in the high chair position.

A Two Brothers muffler is fitted, which lightens the rear of the quad and has great acoustics.

The sprocket is 3 teeth bigger than stock. Valera always rode on stock sprockets and didn't notice a significant difference when switching to a bigger sprocket.


Overall, sport quads are great for tricks and relatively easy to prepare. No protection is needed, since the big protruding wheels fully protect the quad in sideways rollovers. The stock grab bar is easily replaced with a 12 o'clock bar. The engine and suspension don't need modifications. The stock sprocket is quite enough.

Recommend
Magazine Handlebar Installation XSR125 Magazine Free Ride Session 2026 Supermoto Parkour GSW 2023 Magazine Arlen Ness Oval Stage 2 Air Cleaner