Motorcycle Oil Change
The oil change interval, as well as the oil capacity and type, are given in the motorcycle's service manual. Manuals can be downloaded, for example, here: carlsalter.com/motorcycle-manuals.asp. For sport bikes this is usually 10W-40 oil, about 2.5 liters, every 6,000 km. The oil filter can be changed once every two oil changes.
Oil change step by step:
- Warm the engine up to operating temperature.
- Get access to the drain bolt, for example remove the belly pan (lower part of the fairing) if you are servicing a sport bike.
- Unscrew the filler cap.
- Place a container of at least three liters under the drain bolt and unscrew the bolt. To avoid dropping the bolt into the drain container, it's recommended to loosen the bolt with a wrench and unscrew it by hand. Do it quickly, preferably wearing gloves. The oil temperature is 100 degrees. If you drop the bolt, be sure to check that the copper sealing washer is still on it when you take it out: it can fall off.
- The oil drains for about 15 minutes. You can tilt the motorcycle in different directions to drain as much used oil as possible, but it isn't critical.
- Get access to the oil filter if necessary. This may require removing the cage, the expansion tank or part of the fairing, depending on the motorcycle.
- Unscrew the oil filter. It's best to use a special wrench. If you don't have one, a chain wrench will do. You can also pierce the filter with a screwdriver or a long nail and unscrew it. Oil will pour out of the filter and its seat, so place the drain container underneath.
- Install a new filter:
- Pour a little oil into the filter.
- Lubricate the sealing ring with oil.
- Screw it in by hand until it stops.
- Tighten it slightly with a wrench.
- Pour fresh oil into the filler neck. A funnel, for example one made from a bottle, is handy.
- Screw on the filler cap.
- Run the engine for 2 minutes. Then wait 5 minutes and check the oil level. To do this, stand the motorcycle upright; if there is a sight glass, check the level in it; if a dipstick is used, unscrew the dipstick, wipe it, put it back in the hole and pull it out. The oil level should be between the maximum and minimum marks, preferably in the middle. If the level is below the minimum, top up the oil and repeat the procedure.
Don't pour used oil out on the street. You can use used oil to coat the floorboards in your garage so they don't rot, or the gate hinges so they don't squeak :)
For stunt riders:
Before overfilling the oil, find out whether your motorcycle needs it and, if so, by how much. Don't overfill the oil if you are a beginner and can't ride a wheelie for several minutes. On some motorcycles it is advisable to modify the crankcase ventilation when overfilling the oil.