Podolsk,
14 Lobacheva st.
To contact page
RU EN
Tue-Fri 11:00-20:00
Sat-San 11:00-17:00
Mon - Day off

How to Do a Burnout

A burnout is a trick in which the rear wheel breaks loose and spins thanks to front brake braking and shifting body weight forward. It can be done on the spot or on the move along various paths.

Motorcycle

It's enough to fit side protection to the motorcycle, since you may drop it on its side while training. An easy-pull clutch master cylinder will come in handy, since you'll be pulling the clutch constantly. With a stock master cylinder your fingers will tire much faster. Rear tire pressure doesn't matter much. Stock pressure is quite fine for training. It's advisable to adjust the brake lever as close to the grip as possible. This reduces the load on your fingers and gives you a better feel for the brake.


Asphalt

The asphalt on the training lot shouldn't be dusty. This is easy to tell from the front wheel. If it's covered in dust, the asphalt is unsuitable. The texture doesn't matter much, but on coarse asphalt the tire will wear faster :)


Stationary burnout

This is the easiest way! You can start with the front wheel braced against a wall.

Important points:

  • Don't back off the throttle when releasing the clutch, that is, keep the throttle steady. Instinctively you want to close the throttle, but you mustn't.
  • Press down on the fork as hard as possible at the moment you dump the clutch, that is, rise up on your arms.
  • Lock the front wheel completely. Don't just drag the brake: squeeze the front brake hard and don't let go. At first it won't be easy to hold the brake squeezed while twisting the throttle.

Straight-line burnout

The main difference from a stationary burnout is that you have to start the burnout on the move. Actually it's easier, since you can additionally load the fork by braking the front wheel. So on the move you can break the rear wheel loose at low revs (4,000–6,000).

Important points:

  • Shift your body weight as far forward as possible, rising onto your toes if necessary. At first it will feel like you're going to fly over the handlebar. If you don't stop abruptly, you won't :)
  • Keep cooling the front brake. After several attempts the front brakes get very hard.
  • Don't be afraid to ease the front brake to go faster. Even if you release the front brake completely, nothing terrible will happen: the motorcycle will start accelerating quickly in a straight line, and the spin will gradually turn into grip.

Burnout figure eight

A burnout figure eight consists of circles, so you need to learn to circle in both directions. It makes sense to learn circles once you can consistently control movement in a straight line.

Important points:

  • Before entering the circle, it's better to reduce speed with the front brake. When the front wheel turns slowly, the slide happens with less lean, which makes it easier to exit the circle, since you won't have to counter the lean with strong pressure on the handlebar.
  • It's best to ride the circles at high revs. This gives you a margin of revs for when you need to lower them. If the revs drop to idle, the motorcycle will stall.
  • Concentrate more on the handlebar than on the footpegs. Lean the motorcycle by shifting your body weight onto your arm, not by pressing the footpeg with your foot.
  • Before exiting the circle, ease the front brake so the motorcycle straightens up and goes straight. It's best to lower the revs for a softer exit.

If you have comments or additions, write to us and we'll update the article! And always wear a full set of riding gear!

Recommend
Magazine Ouest Bike Show 2019 Magazine Czech Stunt Days 2019 French Stunt Style Romain Jeandrot